Wiring

[Bill E]

Well I have ordered the ClearVue and getting to the point of setup. Well at least in my head. Garage is a mess. I have posted in the past and been helped so I'm back for more. Let me start by saying if I am unsure about anything I will pay money for a professional installation and it looks like I will be paying. Burning down my home due to bad installation seems to be a bad return on my money. But that does not negate my curiosity. I also like to know what is being done in an install by a professional.

I have purchased the Clearvue, Relay and remote. All from links on this website. I think I have a good picture as to what it takes to the get the motor wired. However why is there no neutral running from the panel to the motor? It looks like one is not needed but why? If my reading is correct, when the 110 is connected to the relay coil for the remote a neutral is connected but nothing from the panel to the motor.

Also when the x10 is connect to the relay coil there is not ground?

It seems to me I can follow the diagram but am missing out on some electrical knowledge as to how electricity is going to flow in this set up.


thanks for any insight.

Bill